I replaced my Printrboard controller board due to some mysterious damage (read about it here [forums.reprap.org]).
I flashed the board with the same Marlin firmware I'd used on the previous Printrboard. Everything seemed to work ok (with the exception of the fan). Started a print run and after about 3 layers into it, the steppers started jamming/sticking. Started with the y-axis, but eventually they were all doing it. Could it be the voltage is too high?
I flashed the board with the same Marlin firmware I'd used on the previous Printrboard. Everything seemed to work ok (with the exception of the fan). Started a print run and after about 3 layers into it, the steppers started jamming/sticking. Started with the y-axis, but eventually they were all doing it. Could it be the voltage is too high?